Paluzzi Property Inspection
Paluzzi Property Inspection
129 S. Phelps Avenue, #8
Rockford, IL 61108
Phone: 815-229-6010
Cell: 815-978-7031

Email Us
 
  » Home

  » Who We Are

  » What We Inspect

  » ASHI Standards of Practice

  » EPA Radon Map of IL

  » About Radon

  » About Mold

  » Newsletter

  » Request a FREE Quote

  » Make an Appointment

  » Contact Us

  » FAQ

  » Great Links

  » Homeowner Encyclopedia

  » Phone: 815-229-6010   » Phone: 815-229-1058
ASHI CERTIFIED HOME INSPECTOR

Virtual Home Inspection Tour
Exterior Insulation Finish Systems (EIFS)

previous   1 2 3 4   next

What's The Difference Between EIFS and Stucco?
Materials

A traditional hard-coat stucco exterior system is extremely durable because it essentially covers your home with a layer of rock. Cement stucco is made of sand, a small quantity of lime, Portland cement and water. Basically, it is a fine-grained concrete that is attached to your house using a waterproof barrier paper, galvanized wire mesh and metal flashings (devices that channel water to the exterior of a wall). The stucco's facade is meant to be a primary barrier, but a secondary or "concealed" barrier directs any water that gets behind the facade to the exterior. This creates a dual barrier to wind-driven rain, snow and ice. Barrier EIFS on the other hand, uses a multi-layer "synthetic" stucco that is much softer than traditional stucco.

Breathability

While it has the appearance of stucco and is installed the same way; EIFS has some very unique properties. One of the most important differences is that Barrier EIFS will not allow water to pass back through its coating in vapor form once moisture gets behind the system. By contrast, traditional stucco is a porous material; which will permit moisture to move in and out of the wall cavity.

Installation

Barrier EIFS consists of a base coat and finish coat applied over an EPS board that is attached directly to the sheathing underneath using fasteners or adhesive. The system provides no opportunity for water to drain out once it penetrates behind the EPS board. Traditional stucco, on the other hand, is applied over a wire mesh, and installed with standoffs that allow space behind the stucco for "weeping" of water. No EPS or Styrofoam board is used in a traditional stucco exterior.

EIFS or Stucco, what do you have?

There are tests that any homeowner can perform to determine whether he or she has EIFS or traditional stucco.

The Knock Test

Knock on an outer "stucco" wall of your home. If it sounds hollow, there is a good chance you have EIFS. If it feels like you are knocking on a stonewall, it is more likely that you are knocking on traditional "hard-coat" stucco.

The Touchy Feely Test

Put your hand under the bottom edge of the cladding near the foundation, assuming that is possible (another common installation error occurs when the EIFS is installed below grade, making this test nearly impossible). If you can feel that the cladding comes out away from the foundation 3/4 of an inch or more, chances are you have an EIFS cladding. This is because the EPS board used in EIFS makes the system extend farther away from the wall than a traditional stucco system.

The Penetration Test

Inspect some of the penetrations in the stucco. Most installers of EIFS do not create proper joints around penetrations such as light fixtures, gutter straps, or doorbell/intercom devices. Remove one or more of these items and check for the foam board used in EIFS. If you see a Styrofoam-like board, you have EIFS. Traditional stucco exteriors do not use this component.

previous   1 2 3 4   next



© 2011-2018 LazrWeb all rights reserved